Attention to the quality control of honing pipe

- May 10, 2020-

It is also necessary to pay attention to the following points:

1. The stroke of the equipment should not exceed the width of the honing, otherwise, it may seriously damage the honing gear.

2. In the control of honing amount, its value should be controlled within a reasonable range. Moreover, the control of the honing time is also the same, and the recommendation is about two minutes.

3. The material of the honing gear is relatively brittle, so it is strictly forbidden to beat it, so as not to damage it and make it unusable.

On how to improve the surface finish of the honing tube, it is not difficult to achieve the goal, because you can start from the honing process and then achieve it. Further, select the appropriate honing oilstone, and control the roughness so that it is within the normal allowable range, then the above requirements can be met. However, in some cases, it is necessary to pay attention to the material used for the honing tube and the hardness of the material, so that it can be considered comprehensively to avoid problems.

A brief introduction to the honing tube honing tool and its smoothness guide, I hope everyone can benefit from it, and come to understand the product further, and these are also the theoretical basis for our future research work.

https://www.ht-tube.com