How to improve the finish of the honing pipe

- Jul 10, 2019-

A steel pipe generally obtained by a honing process is called a honing pipe. In the honing of honing pipes, the use of honing tools is more common, and one of the more common ones is honing gears.

        

The honing gear is made up of a base plus abrasive. It is used for honing, mainly to clean impurities and burrs on the surface of the material to improve the surface finish. However, when we use this kind of honing tool, we also need to pay attention to the following points:

        

1. The stroke of the equipment should not exceed the width range of the honing. Otherwise, the honing gear may be seriously damaged.

        

2. In the control of the amount of honing, the value should be controlled within a reasonable range. And for the control of honing time, the same requirement, the suggestion is about two minutes.

        

3, the material of the honing gear, because it is relatively brittle, it is strictly prohibited to knock, so as not to make it damaged and can not be used.

        

As for how to improve the surface finish of the honing pipe, it is not difficult to achieve the goal, because it can be achieved from the honing process. Further, the above requirements can be achieved by selecting a suitable honing stone and controlling the roughness to within the normal allowable range. However, in some cases, it is necessary to pay attention to the material used in the honing tube and the hardness of the material so that it can be considered comprehensively to avoid problems.


http://www.ht-tube.com/