Improve the finish of the Precision Honed Tube

- Jan 28, 2021-

  A kind of steel pipe obtained by honing process is called honing pipe. In the honing process of honing tubes, the use of honing tools is more common, and one of the more commonly used ones is honing gears.

   honing gear is made up of matrix plus abrasive. It is used for honing, mainly to clean up the impurities and burrs on the surface of the material, thereby improving the surface finish. However, when we use this kind of honing tool, we also need to pay attention to the following points:

  1. The stroke of the equipment should not exceed the width range during honing, otherwise, the honing gear may be seriously damaged.

  2. In the control of honing amount, the value should be controlled within a reasonable range. And for the control of the honing time, the same requirement is also required, and the suggestion is about two minutes.

  3. Since the material of honing gear is relatively brittle, it is strictly forbidden to beat it to prevent it from being damaged and unusable.

   Regarding the question of how to improve the surface finish of the honing tube, it is not difficult to achieve the goal, because the honing process can be started and then realized. Furthermore, by selecting a suitable honing stone and controlling the roughness to within the normal allowable range, the above requirements can be met. However, in some cases, it is still necessary to pay attention to the material used for the honing tube and the hardness of the material, so that it can be considered comprehensively to avoid problems.

   A brief introduction to the honing tool of the honing tube, as well as the guidance of its finish, I hope everyone can benefit from it and come to understand the product further. At the same time, these are also the theoretical basis for our future research work.

https://www.ht-tube.com