In the honing process of honing tubes, the use of honing tools is more common, and one of the more commonly used ones is honing gears, so the following is a brief explanation.
The honing gear is composed of a matrix plus abrasives. Use it for honing, mainly to remove impurities and burrs on the surface of the material, so as to increase the surface finish. However, when we use this kind of honing tool, we also need to pay attention to some matters, the main ones are:
(1) The large stroke of the equipment should not be greater than the large width during honing, otherwise, the honing gear may be seriously damaged.
(2) In the control of the amount of honing, the value should be controlled within a reasonable and appropriate range. And for the control of the honing time, the same requirement is also required, and the suggestion is about two minutes.
(3) Since the material of the honing gear is relatively brittle, it is strictly forbidden to hit and knock, so as not to damage it and make it unusable.
https://www.ht-tube.com/