The honing process of hydraulic cylinder honing tube and which workpiece parameters,In the honing process of hydraulic cylinder honing pipes, honing tools are widely used, and the more commonly used one is honing gears . The honing gear is composed of a matrix plus abrasives. Use it for honing, mainly to remove impurities and burrs on the surface of the data, so as to improve the surface finish. However, when we use this kind of honing tool, we also need to pay attention to some things. The first is: the large stroke of the equipment should not exceed the large width during honing, otherwise, the honing gear may be severely damaged. . In the control of the amount of honing, the value should be controlled within a reasonable and appropriate range. And regarding the control of the honing time, the same requirements apply, and the suggestion is about two minutes. The raw material of honing gear is relatively brittle, so it is forbidden to hit and hit, so as to prevent it from being damaged and cannot be used. In the process of production of hydraulic cylinder honing tubes, most of the honing machines are semi-active, often with active measuring equipment, and can also be classified as active production line operations.
https://www.ht-tube.com/