Fixing and rotating angle of the roller frame

- Mar 08, 2019-

In the daily life of the roller frame, it is easy to stick to dirty things, especially the dirty things on the wheels are difficult to clean. How should the roller frame be cleaned?

1. Prepare a dedicated roller frame cleaning machine.

2. Remove the bracket wheel and other disassembly parts of the tube wheel before cleaning.

3. Put the disassembled parts in the container, add professional cleaning agent and water according to the ratio of 1:5, and carry out simple cleaning. Note that the infusion time should not be too long.

4. Use a clean rag to rub a cleaning agent that is more than 5, and wipe the entire roller frame to remove surface stains.

5. After all parts have been cleaned, wipe them off with a dry rag, then pour the original curing agent to wipe the surface of the roller frame.

6. Finally, install all the disassembled.

In the process of running, the roller frame mainly refers to the friction force of the welding piece and the active roller. To a certain extent, it mainly drives the rotation of the circular welding piece, so that the welding of the ring-shaped welding seam can be completed, and the welding speed can be passed through the roller frame. Active roller speed to adjust. The rollers should always be on the same axis, making the workpiece less prone to deformation and slippage when rotated. The adjustable roller frame has three types: manual screw adjustable, manual bolt shift and electric slide shift. Different diameter cylinders are available by adjusting the center distance of the rollers.

The arrangement of the roller frame pays attention to the laying length of the roller and the main pipe during the operation. To a certain extent, the base is kept parallel to the ground, and the bottom should be thoroughly cleaned before being placed to prevent the incorporation of impurities. After the roller frame is arranged, start installing the universal wheel, insert the wheel into the card according to the gear port of the bracket, then rotate it 90 degrees clockwise and tighten it.

The fixing of the bracket of the roller frame is fixed to a certain extent to effectively maintain the verticality of the bracket, and the angle of the handle bracket is adjusted by the fine adjustment, and the steel structural connector is correctly installed, and the power-off operation is remembered in the safety process. After all the procedures are completed, the forks must be placed vertically against the gear port when the casters are installed. The casters and the platform should be kept in a vertical plane. When the test is started, the safety device is turned on and then the power supply is turned on to keep the working environment dry.www.ht-tube.com