The method of improving the smoothness of the honing tube
Generally, a kind of steel pipe obtained by honing process is called honing pipe. In the honing process of honing tubes, it is relatively common to use honing tools, and one of the more commonly used ones is honing gears.
Honing gears are composed of a matrix plus abrasives. Using it for honing is mainly to clean up impurities and burrs on the surface of the material, so as to improve the surface finish. However, when we use this kind of honing tool, we also need to pay attention to the following points:
1. The stroke of the equipment should not exceed the width range during honing, otherwise, the honing gear may be seriously damaged.
2. In the control of honing amount, its value should be controlled within a reasonable range. Moreover, the same requirement applies to the control of the honing time. The recommended time is about two minutes.
3. The material of the honing gear is relatively brittle, so it is strictly forbidden to beat it, so as not to damage it and make it unusable.
As for how to improve the surface finish of the honing tube, it is not difficult to achieve the goal, because it can be achieved from the honing process. Further, choose a suitable honing stone and control the roughness so that it is within the normal allowable range, then the above requirements can be met. However, in some cases, it is still necessary to pay attention to the material used for the honing tube and the hardness of the material, so that it can be considered comprehensively to avoid problems.
A brief introduction to honing tube honing tools and guidance on their smoothness, I hope everyone can benefit from it, and come to know more about this product, and these are also the theoretical basis for our future research work.
https://www.ht-tube.com/