Self aligned tank welding roller safety operation procedures

- Jul 30, 2019-

Self aligned tank welding roller should be installed in a strong, ventilated, rainproof, moisture-proof, dust-proof, and away from severe vibration, bumpy places, it is strictly prohibited to spray corrosive liquid on the equipment. When the main and driven roller frames are installed at the same time, it is necessary to ensure that the main and the follower frames are at the same level, the center line is on the same straight line, and the error is controlled within 3MM. It is recommended to measure the main and follower frames diagonally. Adjustment, when moving the roller frame of KT, JT, JTD type roller frame, special attention should be paid to the angle between the working center of gravity and the center of gravity of the roller should be controlled within 45~110 degrees.

 

Placement of workpiece requirements: The diameter of the workpiece should be strictly in accordance with the provisions of the manual. Otherwise, it is prone to safety accidents and the length of the workpiece. If the equipment is a master and a slave, the length of the workpiece should be controlled within 10M. The rigid rubber wheel is only suitable for working under normal temperature. In special cases, the maximum temperature of the workpiece and the steel rubber wheel is not allowed to exceed 75 degrees, otherwise there is a possibility that the rubber wheel is damaged. When using, the roller should be in full contact with the workpiece. It is forbidden to contact the roller with the weld or the sharp part. At the same time, when the workpiece is hoisted, it is strictly forbidden to hit the roller to prevent the roller or other components from being damaged. If the equipment is not fixed, the strong impact may cause The whole machine is subverted.

 

Since the Self aligned tank welding roller is gradually adjusted from high speed to high speed at the start, it is strictly forbidden to separate the human machine during operation, and it is strictly forbidden to stand in the radius of the workpiece. In order to ensure the performance of the equipment, each transmission component should be filled with lubricating oil before use. The machine should be inspected regularly after using it for a period of time.

 

https://www.ht-tube.com/