Knowledge

Constant pressure of large diameter thick wall honing pipes

1. In the shedding cutting stage, this constant-pressure quilting, due to the rough hole wall at the beginning, the contact area between the whetstone and the hole wall is small, the contact pressure

Causes of mechanical leakage of Honed Seamless Steel Tubes

Factors of mechanical leakage of Honing Cylinder Tubes

Treatment method of inner diameter defect of Hydraulic Honing Pipe

How to deal with the defects of the inner diameter of the honing pipe--the pits and pores on the surface of the quilted pipe are also related to the defects of the pipe itself. We should try to avoid

Formation and Repair of Strain Marks on Piston Rod of Oil Cylinder

If the piston rod of the oil cylinder is strained during use, then we must repair and deal with it in time. I hope you can remember this, because the lighter will affect the normal or it will affect t

High frequency quenching process for the piston rod of the shared cylinder

The piston rod of the oil cylinder is a connecting component used to support the piston rod to do work. It will repeatedly perform events under some conditions such as low temperature, high speed, dry

Explanation of exhaust operation of hydraulic cylinder

The normal working condition of the cylinder piston rod is that the air inside it is evacuated. Therefore, after the hydraulic press is installed, the hydraulic device of the hydraulic system should b

Repair process of piston rod Guide Rod

The editor introduces the repairing process of the piston rod. (1) Clean up the welding position first, and then use damp soil to get the pull marks around.

The design of the Hard Chrome Bars

​The piston rod is a connecting member suitable for the work of the piston rod, and most of them are used in hydraulic cylinders and cylinders to implement fitness exercises. It is a fitness exercise

Precautions for the installation of piston rod seals

1. Make sure that the cylinder liner has introduced rounded corners. 2. If the cylinder liner has no rounded corners, please use the installation sleeve.

Straightening method for slight deformation of piston rod cylinders

The piston rod is a key part of the refrigeration compressor, and its parallelism and surface strength are very high. For example, a certain piston rod has a diameter of 63.5 mm and a length of 630 mm

Steps for detecting the beating of the Quenched And Tempered Piston Rod

1. In a four-stroke cycle of repeated movement of the piston rod, check the level and vertical axial vibration of each piston rod to check the actual effect of the comprehensive maintenance of the fit

Selection of draft positioning datum for piston rod technology road

Accurate selection of positioning datum is the key to drawing up mechanical processing technical regulations and fixture planning. The selection of benchmarks is an important issue in the planning of